Step 1

Remove the little yellow senate cam from the top of the clear post.

Step 2

Apply a good amount of glue to the front of the post. (I did it with the post angling forward.)

Step 3

Stick it to Watto's back and hold it tight for at least a minute to let it dry enough to stick when you set it down to dry. The trick is to position the pole so it touches as much of Watto's back as possible. The curve in his back makes it a little tricky.

Step 4

Let it dry for at least an hour.

Step 5

Once it's dry and attached firmly to Watto, stick the base of the pole into the hole on the Commtech chip to support it. The best way is to have Watto facing the length of the chip so the whole thing doesn't tip over.

Tip provided by:  Darth Bunkaroo Andrew Bunk