Cut off the skirt, but keep the rings on.

Step 2

Cut off the pelvis off below the rings with any means possible (it took me 2 hours with a razor).

Step 3

Paint the rings silver.  If you get silver paint on any other part of the body, touch it up with the black paint.

Step 4 Optional

Cut off your choice off cylinder-like circuits from the circuit board leaving extra wire. Then push the metal ends into the rings. If you don't have a circuit board, sculpey will do fine.

Step 5

Fill in inside the rings with sculpey, then poke the end of the stand from the Palpatine camera into the sculpey to make it's imprint.  Harden sculpey in any way possible.

Step 6

Cut the lightsaber in half, then melt it a little bit to make it look like it got sliced in half. paint the end of it silver

Step 7

Cut the blade off the other half of the lightsaber and melt it a little too for the handle.  Tada! let your imagination be your guide!

Recipe provided by: